3
8310-A2-GZ40-20
January 2000
MVL Card Installation Planning
H
Each Hotwire chassis is shipped with one of the following installation
documents:
Document Number
Document Title
8600-A2-GN20
Hotwire 8600 Digital Subscriber Line Access
Multiplexer (DSLAM) Installation Guide
8610-A2-GN10
Hotwire 8610 DSLAM Installation Instructions
8800-A2-GN21
Hotwire 8800 Digital Subscriber Line Access
Multiplexer (DSLAM) Installation Guide
8810-A2-GN11
Hotwire 8810 DSLAM Installation Instructions
8820-A2-GN20
Hotwire 8820 GranDSLAM Installation Guide
H
Refer to one of the above installation documents to:
— Install and set up the Hotwire DSLAM or GranDSLAM chassis
— Install the Hotwire 8310 MVL card
— Connect cables
H
After the MVL card is installed, there are configuration procedures that must
be performed before you can begin to use the MVL cards for Internet or
intranet connectivity. Refer to the Hotwire MVL, RADSL and Packet SDSL
Cards, Models 8310/8312, 8510/8373/8374, and 8343/8344, User’s Guide for
more detailed configuration procedures. Access this document using the
instructions on page 2.
Installing the MVL Card
"
Procedure
To install the Hotwire 8310 MVL Card in a Hotwire chassis:
1. If there is a filler plate covering the slot, remove it.
2. Insert the card into the card guides of the slot on the chassis. For the
8600/8610 DSLAM, ensure that the components are facing up.
3. Carefully slide the card into the slot. Gently, but firmly, push the card until it
engages its mating connectors on the backplane.
4. Verify that the OK SYSTEM indicator on the card’s faceplate is ON (green).
If not, refer to the appropriate chassis installation document.
5. Secure the card by fastening the screws on each end of the faceplate. This is
required to maintain proper gasket pressure on the faceplate as well as
proper air flow.
