4
August
2001
6050-A2-GZ40-20
Cables You Need
The POTS splitter card has three interfaces and each of the three POTS Splitter
card connectors requires a 50-conductor cable with a 50-pin Telco connector. Use
a minimum of 24 AWG.
Each DSL port at the DSLAM uses one pair of copper wires out of the 25 pairs on
each 50-position connector. The following tables show the cables that can be used
to connect 6050 and 7020 POTS splitter cards to the DSL interface at the DSLAM.
Table 1. 6050 24-Port DSL POTS Splitter Card
DSL Port
Cards
DSLAM Connectors
POTS Splitter Card to DSLAM
Combination
Cabling*
4-port cards:
8310
8510
8540
8546
8810 front connectors
One 6050 POTS splitter card to
six 4-port DSL cards
One straight-through cable
8610 or 8820 rear
connectors
One 6050 POTS splitter card to
two 4-port DSL cards (leaves
16 POTS splitters idle)
One Y-cable
8820 rear connectors
One 6050 POTS splitter card to
six 4-port DSL cards
Cable with single connector to six
cables with single connectors via
connector block
12-port cards:
8312/8314
8365
8373/8374
8610, 8810, or 8820 rear
connectors
One 6050 POTS splitter card to
two 12-port DSL cards
One Y-cable
12-port cards:
8314
8365
8374
8620 rear connectors
One 6050 POTS splitter card to
two 12-port DSL cards
One Y-cable
Table 2. 7020 12-Port TDM SDSL POTS Splitter Card
4-Port TDM
SDSL Cards
DSLAM Connectors
POTS Splitter Card to DSLAM
Combination
Cabling*
8774-B1
8775-B2
8776-B1
8810 front connectors
One 7020 POTS splitter card to
three 4-port cards
One straight-through cable
8610 or 8820 rear
connectors
One 7020 POTS splitter card to
two 4-port cards (leaves 4 POTS
splitters idle)
One Y-cable
8610 or 8820 rear
connectors
One 7020 POTS splitter card to
three 4-port cards
Cable with single connector to
three cables with single
connectors via connector block
* Use 24 AWG unshielded twisted pair CAT5 cable. See
Connector Pin Numbers
on page 20 and
Y-Cable Wiring
on page 21.
