Paradyne FrameSaver SLV 9124, Technical Reference

Page: 229 / 346

Operation and Maintenance
10-17
9124-A2-GH30-00 June 1999 - Preliminary
Table 10-6. Health and Status Messages (5 of 6)
Message What To Do What It Indicates
OOF at Network n An Out of Frame (OOF)
condition is detected on the
network interface.
1. Incompatible framing
format between the
network and the
FrameSaver unit.
2. Network cabling
problem.
3. T1 facility problem.
Cleared when a reframe occurs.
1. Check that the framing format
for the network interface is
correct.
2. Check that the network cable
is securely attached at both
ends.
3. Contact your network provider.
Primary Clock Failed A failure of the primary
clock source configured for
the NAM is detected and
the secondary clock is
providing the timing for the
NAM.
This condition clears when
the configured primary
clock is restored.
1. Check that the cable is
securely attached at both ends
for the primary clock source
interface.
2. Contact the network provider.
Primary & Secondary
Clock Failed A failure of the primary and
secondary clock sources
configured for the
FrameSaver unit are
detected and the internal
clock is providing the timing
for the unit.
The clock source will not
automatically switch from
internal until the primary
clock source returns.
1. Check that the cable is
securely attached at both ends
for the primary and secondary
clock source interfaces.
2. Contact the network provider.
SLV Timeout,
DLCI nnnn,
frame relay link
3
An excessive number of
SLV communication
responses from the remote
FrameSaver unit have been
missed on the specified
multiplexed DLCI; the DLCI
is not suitable for user data. Contact your network provider if
the problem persists.
If a DBM is present, backup is
initiated automatically.
Yellow at DSX-1 A yellow alarm signal is
received on the DSX-1
interface. DTE has
detected a LOS or OOF
condition. 1. Check that the DSX-1 cable is
securely attached at both
ends.
2. Check the status of the
attached equipment.
3
Does not apply to a TS Management Link DLCI.