Paradox MG5050, Programming Manual

Page: 28 / 72

28 Programming Guide
Table 7: IP/GPRS Registration Status
WinLoad / BabyWare / PCS Series Connection Settings
Refer to the Installer Quick Menu on page 65 for alternate programming of PC phone number, panel ID, and PC password.
Communication Report Codes
Communication Restore Report Codes
Main Menu Trouble Sub-Menu Trouble Menu
[1] IP/GPRS module registration status [1] OFF = Unregistered
[1] Slow Flash = Registering...
[1] ON = Registration OK
[2] IP/GPRS module error [7] No IP/GPRS module
[8] Ethernet cable unplugged/GSM no service
[9] No IP address acquired by module/GPRS network trouble
[3] IP/GPRS programming error [7] No IP address (not programmed)
[8] No IP port (not programmed)
[9] No IP account (not programmed)
[10] No Access point name (not programmed - GPRS only)
[4] IP/GPRS registration error [7] Cannot connect
[8] Invalid profile
[9] Invalid format
[10] Account already registered under another MAC address
Register module When all troubles are cleared, press [
ARM
] to register module.
[780] ___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/
SMS SITE NAME
[920] ____/____/____/____/____
PORT
(
DEFAULT
= 10000)
[921] ___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/
ACCESS POINT NAME
(
APN
)
PART
1 (
E
.
G
.
INTERNET
.
COM
)
[922] ___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/
ACCESS POINT NAME
(
APN
)
PART
2
[923] ___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/
USER NAME PART
1
[924] ___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/
USER NAME PART
2
[925] ___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/
PASSWORD PART
1
[926] ___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/
PASSWORD PART
2
[927] ___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/___/
INSTALLER SOFTWARE PASSWORD
(W
IN
L
OAD
/ B
ABY
W
ARE
) (
DEFAULT
=
ADMIN
)
[879]* ____/____ PCS Series RF jam [880] ____/____ N/A
____/____ PCS Series no service ____/____ IP100 no service
____/____ PCS Series module supervision lost ____/____ IP100 supervision lost
____/____ Receiver fail to communicate (GPRS) ____/____ IP receiver fail to communicate
[881]* ____/____ PCS Series RF jam [882] ____/____ N/A
____/____ PCS Series no service ____/____ IP100 no service
____/____ PCS Series module supervision lost ____/____ IP100 supervision lost
____/____ Receiver fail to communicate (GPRS) ____/____ IP receiver fail to communicate
* This section also applies to GSM communication programming.