642
9
(messages) from a Paradox Memory Key to the keypad’s memory.
Insert a programmed Paradox Memory Key into the keypad
connector labelled “key” (see Figure 1 on page 29). After entering
Keypad Programming Mode, select section
[4]
and then press the
[
ENTER
]
key. The display reads:
Reading Key
. The keypad will
copy the contents from the key into keypad memory. This may take
approximately 15 seconds. Once the information has been copied,
the keypad will emit a confirmation beep.
[5] Write Key
Use this option to copy the programmed options and labels
(messages) from a keypad to a Paradox Memory Key. Insert the
Paradox Memory Key into the keypad connector labelled “key” (see
Figure 1 on page 29). Make sure the Memory Key’s jumper is on.
After entering Keypad Programming Mode, select section
[5]
and
then press
[
ENTER
]
. The display will read:
Writing Key
. This may
take approximately 15 seconds. When the process is complete, the
keypad will emit a confirmation beep. Program one keypad, copy its
contents to the memory key as explained in this option, then program
as many keypads as required using option
[4]
(see above).
[6] Set Language
Use this option to set the keypad’s display language. Depending on
which language set you ordered, the keypad can store up to 9
languages. Use the
[
U
]
[
V
]
keys to scroll through the list. Press
[
ENTER
]
to save the selection.
[7] Keypad Lock
Use this section to prevent your keypad code from being set to default in
case of an accidental or unauthorized event. After selecting section
[7]
,
press keys
[1]
,
[4]
, and
[7]
to lock your code, and then press the
[
ENTER
]
