- 13 -
Installation Guide
Connect70
Coarse azimuth adjustment is performed by rotating the antenna on the mounting pole, and
tightening the 3 vertically aligned clamping bolts when a satisfactory coarse azimuth is achieved.
For fine azimuth adjustment, slightly loosen off the 3 x M8 nuts (A) located on the underside of
the Az/El Mount Assembly. Adjust the fine azimuth by turning the plasti-bolt (B) until the desired
angle is achieved. After achieving the desired azimuth, tighten the three base plate nuts (A).
Refer to page 17 to calculate azimuth angle for pointing the antenna.
Azimuth
Adjustment
A
B
