17
FIGURE 23
0
1
2
3
4
5
6
1/2
1/2
1/2
1/2
1/2
1/2
STEP 23
• Attach both 2 X 16-1/2” PLATES (18) to the bushing on the BACK PAD SUPPORT (14) using one 1/2 X 5-1/2” BOLT (47) and one 1/2”
LOW HEIGHT LOCKNUT (50).
(NOTE: Securely tighten, then back nut off 1/4 turn to allow the 2 X 16-1/2” PLATES (18) to rotate
freely.)
See FIGURE 23.
85
78
• Attach WOLFF SLEEVE (2) to the BACK PAD SUPPORT (14) using one 1/2 X 3-1/2” BOLT (43) and one 1/2”
LOW HEIGHT
LOCKNUT (50).
(NOTE: Securely tighten, then back nut off 1/4 turn to allow the BACK PAD SUPPORT (14) to rotate
freely.)
See FIGURE 23.
• Slide one HINGE TAB (78) on each side of shaft on WOLFF SLEEVE (2). See FIGURE 23.
• Stick one 1-1/4” RUBBER BUMPER (85) on the BACK PAD SUPPORT (14) approximately 1/2” from the end of BACK PAD
SUPPORT (14).
14
50 1/2” LOW HT.
2
1
18
43 1/2 X 3-1/2”
47 1/2 X 5-1/2”
50 1/2” LOW HT.
•
At this time,
SECURELY
tighten the FRAME SUPPORT (1) to the BASE (10) and the FRONT UPRIGHT (11).
TIGHTEN
TIGHTEN
10
