q
A
A
www.paraavis.com
Read and follow all WARNINGS, WARRANTY and INSTRUCTIONS for products.
Read page 2 of this manual.
5
SPACE 7 cell reserve canopy. Manual.
Introduction
NOTE.
We require that the rigger packing these canopies be completely familiar with ram-air
type parachutes. Although we do not require a special rating, the owner/jumper should be sure
that the rigger thoroughly understands a ram-air parachute. Having a square reserve on
backwards would be a serious matter!
Lay the harness and container on a smooth clean surface as if the wearer were face down, head
toward the canopy. Lay the canopy out and straighten the line groups. The front first and second
line groups go to the front risers, the third and fourth line groups go to the rear risers. The
smooth side of the grommets in the slider goes toward the harness.
Attach the connector links to the corresponding risers temporarily and do a complete continuity
check on each link to insure proper sequence, and then tighten the links. Clear each set (left and
right) of upper control lines (steering lines). Lower control lines should pass through the rear
grommets of the slider (clear of the suspension lines) then through the Type I webbing guide
loop located on the rear riser just below the L-link and then through their respective guide rings
on the rear risers. Attach the steering toggles to the lower control lines by inserting the looped
lower end of the lower control line through the grommet in the toggle from the Velcro® side,
and then passing the bottom end of the toggle through the loop and cinching the loop snug
around the toggle. If practical, the rigger should then carefully inflate the reserve as a final
continuity and assembly check.
Pass the long bridle webbing through the deployment bag’s loop, then pass the large loop end of
the webbing through the smaller loop end and cinch snug. Next pass the large loop end of the
bridle through the pilot chute’s loop, and then pass the entire pilot chute through the large loop
of the bridle.
WARNING!
This bag assembly must not be attached to the reserve canopy.
