13
art.nr
. 8822150 Rev 2021-01, Publ. 2021-03-23
Panthera
AB reserves the right to make technical changes if required
SETTINGS
4) The angle of the backrest
(Fig. 9)
1)
Fold the backrest forwards.
2)
Loosen the lock screws (1) a few rotations using a 17 mm cap key. Repeat this process
on the other side.
3)
Adjust the angle of the backrest using the adjustment screws (2) on both sides. Using
the 4 mm Allen key, unscrew the adjustment screws to tilt the backrest forwards. Tighten-
ing the adjustment screws will allow the backrest to tilt backwards.
It is important to adjust both sides equally to avoid the backrest tubing becoming crooked.
Test this by placing the backrest in the upright position and checking that both adjustment
screws are touching the frame.
3)
Experiment with suitable backrest angles before tightening the lock nuts (1) on both
sides.
.
5) The tension of the backrest upholstery
(Fig. 10)
You can adjust the backrest upholstery to suit the shape of your back using the straps
located under the flap at the rear of the backrest. This provides good support to the small
of the back.
The backrest upholstery also has a lower flap fastened with Velcro above the seat uphol
-
stery, under the seat cushion. This flap can be moved backwards or forwards to obtain the
required tension in the lower section of the back upholstery (known as the seat bucket)
.
Fig. 8
Fig. 9
1
2
