6
Property of Panthera® Motorsports inc
Flooded engine
If the engine fails to start after repeated attempts, it may be flooded with excess fuel. To clear a flooded
engine:
Electric start engine
1.
Put the engine stop witch at off.
2.
Push the choke know at OFF
3.
Open the throttle fully
4.
Press the start button for 5 seconds.
5.
Wait 10 seconds, then turn the engine stop switch to RUN.
6.
Repeat the electric start engine normal starting procedure.
Kick start engine
1.
Put the engine stop witch at off.
2.
Push the choke know at OFF
3.
Open the throttle fully
4.
Repeat kick start operation approximately 10 times to discharge excessive fuel from the engine.
5.
Repeat the kick start engine normal starting procedure.
If the engine still won’t start, refer to the ‘’If your engine quit or won’t star’’ page.
Stopping procedure/stop switch wiring
Engine stopping signal must be sent to the black wire of the CDI unit. (refer to wiring diagram)
The black wire must be sent to engine ground in order to stop the ignition spark.
Shifting gear
The shift lever is located on the left side of the engine. One full stroke of the shift lever shifts the
transmission to the next higher or lower gear in the shifting sequence. The shift lever automatically
returns to the horizontal position when released.
PM07-18 engine as six forward gears (1,2,3,4,5 and 6). To upshift, raise the shift lever a full stroke. To
downshift, depress the shift lever a full stroke.
Neutral is located between 1
st
and 2
nd
gear. To put engine in neutral, softly half stroke the shift lever
from 1
st
going to 2
nd
or from second going to 1
st
.
