Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, +46-8-761 50 40, www.panthera.se
6)
Enter the rear axle into the attach-
ment. Make sure the chamfer at the end
of the rear axle lines up with the chamfer
on part 4. (picture B)
4)
Place part 5, the bottom clamp over
part 4.
5)
Mount the screws through the parts.
The two longs screws should be on the
”outside” of the chassis and the two
short on the ”inside”. Tighten the screws
ligtly.
7)
Tighten the screw slightly, a few turns,
with allen key 4 mm.
8)
Continue to mount the attachment on
the other side, steps 1-3.
9)
Place the bottom clamp (part 5) on
the axle (part 1). Mount the screws.
Tighten the screw slightly, a few turns,
with allen key 4 mm.
10)
Adjust the rear axle settings to the
desired measure, on both sides.
11)
Finally tighten the 8 screws firmly
with 5,7 nM.