manualshive.com logo in svg

panthera Armrest S3/U3, User Manual & Assembly Instructions, Page: 4 / 4

Share
Download
panthera Armrest S3/U3 User Manual & Assembly Instructions Download Page 4

Panthera AB, Gunnebogatan 26, SE-163 53 Spånga, Sweden, 08-761 50 40, www.panthera.se

Fig. 20

Pull off the foam from the pushbar.  

 Cut approx. 12cm on both sides of the foam.

Remount the two foam parts on the push-

handle.

Fig. 21

Fig. 22

Fig. 20

Mount the plastic sockets that comes with brake kit, 

on both sides of the push handle.

Mount the brake handles and tighten the 
screws.

Both brake handles mounted on the push-

bar.

Fig. 21

Fig. 22

Fig. 23

If the brake handle is short, 33 cm or below, you 

might need to mount the handles as shown in the 

image to make room.

Fig. 24

Summary of Contents for Armrest S3/U3

Page 1: ...lutch the handles hard and keep them activated while you poke the red levers with your finger to make them snap into one of the slots To release the park brake you clutch the hand les until the red levers spring out and releases the brakes and the wheelchair is possible roll Assembly The assistant brake kit contains 2 rearwheels with drum brakes and 2 brake handles with wires and attachments for m...

Page 2: ... to adapt the push handles for the brake handles Ready made push handles has art no 4250047 Fig 8 Fig 9 Fig 10 Mount the included push handle extensions on the push handles Put the push handle in a jaw vice and drill a 3 mm hole straight through 5 mm from the edge Enter the included pin in the 3 mm hole with a hammer Use a sharp object to make a small hole on the back of the push handle grips This...

Page 3: ...ount the push handles on the brackets at the back rest and pull the wires through the back rest upholstery Fig 16 Justera bromsarna med skruvarna vid bromshandtaget resp bromsbackarna Fig 17 Remove the push bar from the wheelchair Loosen the screw on one side with allenkey 4 mm Make sure not to loose the little locking plate whn the pushbar is taken apart Fig 18 Fig 19 Mounting of brake handles on...

Page 4: ...he two foam parts on the push handle Fig 21 Fig 22 Fig 20 Mount the plastic sockets that comes with brake kit on both sides of the push handle Mount the brake handles and tighten the screws Both brake handles mounted on the push bar Fig 21 Fig 22 Fig 23 If the brake handle is short 33 cm or below you might need to mount the handles as shown in the image to make room Fig 24 ...

Reviews:

No comments