If you own a motor that does not fit into either
one of these categories then you will have to
drill a hole in your motor to mount the ball
stud. Look directly in front of the motor cover
to determine where is the best place for you to
drill a hole . The ball stud can be installed
with the ball up or down. The only concern is
that you need to have enough room to attach
the quick disconnect over the ball stud.
(See picture 3) (55-5705 optional bracket is
used in pictures 3)
If you do not have adequate room to attach
the quick disconnect to the ball stud, you will
have to use our flat mounting brackets
(included), in order to give you adequate
room. You will need to drill two holes and
attached the brackets as shown .
(See picture 5)
NOTE: If using the flat mounting brackets,
it is best to keep them as short as possible.
The kicker ball stud should be as close to
the kicker frame as possible.
