2
ELECTRICAL CONNECTIONS
WARNING: Never operate the wireless remote from outside the boat
The RECEIVER:
This
receiver
is designed to operate from any standard 12 volt battery.
1. Connect the ring terminal leads from the
receiver
to the battery. Connect the red lead to the
positive (+) terminal and the black lead to the negative (-) terminal.
2. Connect the receiver two prong molded plug connector to the two prong connector of the motor that
you
are going to operate.
3. The receiver will provide voltage to the motor when commands are received from a learned transmitter
.
The TRANSMITTER:
(In-depth instructions and FCC compliance on following page)
The
transmitter
operates off of a standard 12VDC A23 type battery.
(
Always carry an extra A23 type battery )
ALL TRANSMITTERS COME PROGRAMMED AND ARE FULLY OPERATIONAL WHEN
PACKAGED.
( If the tr ansmitter does not wor k, follow the dir ections below. )
The following is a procedure for programming a new transmitter to a receiver:
1. Enable the transmitter by pressing the power button. The LED will flash twice.
2. Hold down either directional button on the transmitter for about one second.
Apply power to the receiver device
while continuing to press
the transmitter activation device
3. After about one second a relay will click on the receiver.
4. The transmitter is now programmed to the receiver.
TROUBLESHOOTING
Weak Signal
1. Battery may be low. To replace battery, remove the screw on the back of the transmitter. Remove the
back cover carefully, noticing how the rubber membrane is seated in the case. Remove and replace bat-
tery. Reinstall back cover making sure that the rubber membrane is seated in the case. Install screw and
carefully tighten.
Do not over tighten.
Dispose of battery properly.
2. Receiver is obstructed. Move receiver in a direct line with the transmitter. Make sure antenna is not
obstructed.
