Pansat 9000HD, User Manual, Page: 20 / 40

ⓒ 2007 by Panarex Electronics 20
22KHz control is automatically set for each LNB alternative or you can change it by yourself.
2.1.3 LNB Lo-Freq
If the required LNB frequency is not available, select “Standard” and then input the frequency manually using the
numeric keys.
2.1.4 22Khz
In case you are using a dual LNB or two antennas connected to a 22KHz tone switch box, make 22KHz tone switch
“ON” or “OFF” to select an LNB or an antenna.
2.1.5 DiSEqC
• DiSEqC 2X1 & 4X1 are supported.
• Select the port connected to the LNB or LNBF.
2.1.6 Positioner Setting
It is used to set the DiSEqC 1.2 or USALS motor.
If you have no positioner equipment, select “Disable”. Otherwise, you can select either DiSEqC 1.2 or USALS.
1) DiSEqC 1.2 (manual operation)
(1) Current position
Select the position number by using keys (#0~#26:default define, #27~#49: user define)
◀ ▶
(2) Movement
Select East / West by using keys
◀ ▶
.
(3) Store
Please select “Store” and the current position will be saved.
(4) East Limit Set
Move the position to the most eastern position and press OK then East Limit is stored.
(5) West Limit Set
Move the position to the most western position and press OK then West Limit is stored.
(6) Limits Disable
Select Disable limits by using OK key
(7) Go to reference
Select go to reference by using OK key
If the motor shifted to one side(usually it happens after used), you can resynchronize by using DiSEqC 1.2 “go to
reference“ and then go back to programmed mode.