© 2007 PANORAMAdtv ALL rights reserved
12
MON2-3W
and
MON2-3/6.8
User Manual P/N
821525 Rev-E
Please refer to Figure-2c on the following page to familiarize yourself with the rear panel features of the MON
unit. The following sections describe these features and are referenced, by letter, to Figure-2c.
Notes:
1) Items F, G, H, and I apply only to units configured with the MSDI-4 SDI option (factory or field installed).
2) Due to the modular nature of the rear panel, not all openings are populated depending on the model or options
installed. All unused openings will be mechanically secured with appropriate blank panels and/or hole plugs.
4) Only one additional input option module (SDI digital or CVBS analog) can be accommodated per monitor
channel. The I/P switch (Item 5) on the front panel will then be used to switch between the standard primary
CVBS input and whichever optional input module is installed for that channel.
A Power - IEC-320 Connector
Attach a standard IEC-320 power cord between this connector and mains power.
Τ
he front panel Power
LED (Item 1) will glow green to indicate that an operating voltage is present.
B In CVBS - BNC Connector
Connect analog CVBS video signals here. NTSC or PAL standards are accommodated automatically.
NOTE:
Use the front panel Input (I/P) Selector Switch (Item 5) to select analog or option inputs: To select
a CVBS source place the Input Selector Switch in the
DOWN (A)
position. This switch position also
enables input video selections from the Remote Source Select Control connector, if installed.
C Loop CVBS - BNC Female Connector
Signal-through connections to down-stream equipment are supplied here. If you supply down-stream
equipment from this connector, ensure you set the TERM/LIFT toggle switch (Item D) to the LIFT (DOWN)
position. If
no
other equipment is connected via this connector, set the TERM/LIFT switch to the TERM
(UP) position.
D Term/Lift - 2-Position Toggle Switch
This switch terminates the “IN CVBS” connector as required by your configuration. Placing this switch
to the TERM (UP) position inserts a 75
Ω
termination impedance in the video signal. This is the required
position for correct signal levels when down-stream equipment is
not
connected to the “LOOP CVBS”
connector (Item C).
E On/Off - 2-Position Toggle Switch
Individual monitor power switch. Use this switch to turn the power on or off to the associated monitor.
F SDI In - BNC Female Connector (MSDI-4 SDI Option)
Connect SMPTE 259M/EBU601 SDI signals here. This female BNC connector is terminated at 75
Ω.
(MSDI-4 SDI option required.)
NOTE:
Use the front panel Input (I/P) Selector Switch (Item 5) to select analog or digital inputs: To select
an SDI source place the Input Selector Switch in the UP (B) position. Placing the Input Selector Switch in
this position will disable source selections via the Remote Source Select Switch, if installed.
G SDI Loop - BNC Female Connector (MSDI-4 SDI Option)
Signal through connections to down-stream equipment are supplied here. This connector supplies a buffered
replica of the input signal. (MSDI-4 SDI option required.)
Rear Panel Features
Section 2: Operation
(Continued)
