5. Pole/Mast Mounting
In order to mount the antenna to a pole or mast you will need the following supplied parts:
1 x Antenna
1 x U-Bolt
1 x U-Bolt Plate
2 x Washers
2 x Spring Washers
2 x Nuts
The u-bolt assembly allows
fi
tting to masts of between 20-50mm (0.8” – 2”) diameter. Ensure that the selected mounting location can be safely
accessed with the equipment that you have available and mount the antenna so that it has at least 1 metre (3.3’) of clearance from all obstruc-
tions if possible.
T
he antenna must be mounted
at the
top of the pole
so
that the body of the antenna is elevated clear of the metal
pol
e.
The supplied u-bolt bracket can then be used to clamp the antenna to the mast. The u-bolt plate should be held against the antenna and the
u-bolt passed through both the plate and antenna clamping the mast. The supplied nuts and washers can then be used to tighten the
assembly
securely to the mast.
Caution: Do not over
-
tighten the u-bolt as this may damage or distort the mast tube section.
5.a
5.b
5.c
6.
Routing Coaxial Cabl
es
Plan the coaxial cable route to the wireless device to avoid running adjacent to any existing electrical wiring and ensuring that they will not be
subjected to damage.
Secure the cable run using correct size cable clips, so as not to distort/compress the cable. It is important that the cable is not bent sharply –
note that the minimum bend radius for the cable is 25mm (1”) and this should be considered when routing to the cable entry point. Where the
antenna is installed externally, it is good practice to create a ‘drip-loop’ at the entry point to avoid water ingress. Any excess cable must not
be coiled - it should be laid out in a
fi
gure
of
eight
pattern
and
loosely
secured.
SMA (m) connectors are
fi
tted
as standard. A 9mm (0.35”) clearance hole is required for
each
connector – ensure it
protected whilst feeding
through the hole
to prevent damage or contamination
. Other connector
types
are also available
and may required a different size hole.
7.
Commission and Test
●
Carry out VSWR check
on each cable feed
, the VSWR should measure as per the data
sheet
.
●
Connect the cables.
to the 4G/5G device.
