Routing and terminating coaxial cable(s)
D.
Route the coaxial cables away from the antenna, taking care that the cables do not apply stress to the antenna
mounting. It is advisable to observe a minuimum bend radius of 15mm when installing the twin RG174 cables.
The cables should be routed so that they do not obstruct a moving vehicle component.
The cables must not be routed in front of any airbag devices – note that these may be located behind
the windscreen pillar trim and the side of the roof head lining, depending on vehicle specification.
Commission and test
E.
Check LTE/Cellular cable:
• Carry out VSWR check which should measure <2.5:1.
Check GPS/GNSS cable:
• Check the GPS/GNSS cable with DC to measure high resistance.
• Connect the GPS/GNSS cable to the GPS/GNSS receiver and check for satellite acquisition.
European Waste Electronic Equipment
Directive 2002/96/EC
Please ensure that your old Waste Electricals and Electronics are recycled do not throw them
away into standard waste.
RF Safety Note
This antenna should be mounted in such a way that no person is within 20cm (8”) of the
antenna during use.
Notices
F.
RoHS 2: Directive 2011/65/EU
and its subsequent amendments. Homogeneous materials
composing parts that are compliant with this legislation have less than 0.1% by weight each
of lead, mercury, hexavalent chromium, PBB, and PBDE, and 0.01% by weight of cadmium.
Exemption 6.c applies to this product.
R&TTE: DIRECTIVE 1999/5/EC
of 9 March 1999 on radio equipment and telecommunications
terminal equipment and the mutual recognition of their conformity. Compliance is declared according
to:
EN 301 489-1 V1.9.2
Electromagnetic compatibility and radio spectrum matters (ERM);
Electromagnetic compatibility (EMC) standard for radio equipment and services; Part 1: Common
technical requirements -Referencing EN 301 489-3 V1.6.1 and EN 300 440-1 V1.6.1 (2010-08)
– Electromagnetic compatibility and radio spectrum matters (ERM); short range devices; radio
equipment to be used in the 1GHz to 40GHz frequency range; Part 1: Technical characteristics and
Test methods in accordance with EN 300 440-2 V1.4.1 (2010-8) - Electromagnetic compatibility
and radio spectrum matters (ERM); short range devices; radio equipment to be used in the 1GHz
to 40GHz frequency range; Part 2: Harmonised EN covering the essential requirements of article
3.2 of the R&TTE Directive.
Low Voltage Directive: Directive 2006/95/EC
(Electrical Equipment designed for use within
certain voltage limits) of August 2007. Compliance is declared according to:
EN60950-1:
Safety of information technology equipment – according to test specification EN
60950-1:2006 +A11:2009 +A1:2010 +A12:2011.
Waiver: This document represents information compiled to the best of our present knowledge. It is not intended to as a representation or warranty of fitness
of the products described for any particular purpose. This document details guidelines for general information purposes only. Always seek specialist advice
when planning installations and ensure that antennas are always installed by a properly qualified installer in compliance with local laws and regulations.
SW3-683
- www
.panorama-antennas.com
