6
Firmly press down on antenna to affix to
mounting surface, ensure that seal skirt
splays out into surface
Feed cables through hole
1
3
2
Remove nut, washer. Remove pad liner
4
Prepare mounting surface. Drill hole etc.
as per standard instructions
When fitting the nut, it is important to ensure that the cables are held centrally whilst the nut is correctly
started on the threads. The nut should fit freely by hand and only requires a final tighten by spanner to a
recommended torque of 5Nm. It is important not to over-tighten the nut as this may cause damage to the
mounting panel. Remove blanking cap and screw comms antenna whip securely to mounting stud
(where used).
