Copyright © 2014, PANJIT Lighting Technology (Shenzhen) Co., Ltd.
NO.20 FACTORY, FUMIN INDUSTRIAL ZONE , PINGHU COMMUNITY PINGHU SUB-DISTRICT, LONGGANG DIST., SHENZHEN, CHINA.
Tel : +86-755-84686621 Fax : +86-755-84679570 http :// www.panjitlighting.com (Panjit Lighting)
of 4
LNF Series Floodlight Installation Instruction
Ver. 1.1
4
Driver Maintenance
1. Open back cover
⑨
using 5mm hex wrench to loosen 4 X M6 socket hex bolts
⑥
, see Fig. G-1 and Keep bolt set aside.
2. Remove driver tray from junction box by using 3.5mm hex wrench to loosen 4 X M4 socket hex bolt set
⑦
(Keep bolt set aside).
3. Separate driver from driver tray by using 3.5mm hex wrench to loosen 4 X M4 socket hex bolt set
⑦
(Keep bolt set aside).
4. Disconnect waterproof connectors of DC supply end: rotate seal nut then draw out male connector.
5. Rotate stainless M16 connector to right and draw out AC wire.
6. install new driver and undo step 6 to 1 to complete driver replacement and securely tighten all screws.
Electrical Connection
1. Open back cover
⑨
using 5mm hex wrench to loosen 4 X M6 socket hex bolt sets
⑥
, see Fig.
F-1 and Keep bolt set aside.
2. Rotate stainless M18 connector
⑧
to right and draw out AC wire.
3. Pull 3x1.5mm portable cord(not provided, or use other extra hard usage portable cord)
supply wire from customer power supply through stainless M18 connector
⑧
.
4. Using the PJWCM2015 cable connector to connect driver and supply wire (see Fig. F-2 ):
4.1. Tread seal nut, seal clamp and seal ring onto both power supply and driver AC cable.
4.2. connect and lock
supply ground wire to ground wire from green wire of the driver onto
connector and secure 2X side screws by flathead screw driver.
4.3.
connect and lock
supply line conductor to black wire of driver onto connector, and
secure 2X side screws by flathead screw driver.
4.4 .
connect and lock
supply neutral conductor to white wire. of driver onto connector, and
secure 2X side screws by flathead screw driver.
4.5. rotate to tighten seal clamp and seal nut
5. Reinstall back cover to complete the installation.
Make sure the seal ring is
positioned as shown
Warming! To reduce the risk of electrocution:
•
Luminaire must be power off during lamp installation
•
Make sure the equipment is properly grounded
Fig. G-2
Fig. G-1
Fig. F-1
Wiring Diagrams
Fig. F-3
Component parts:
⑥
M6 socket hex bolts + Flat Washer
⑧
M18 connector
⑨
Back cover
Component parts:
⑥
M6 Socket Hex Bolt + Flat Washer
⑦
M4 Socket Hex Bolt + Flat Washer
⑧
M18 Connector
⑨
Back Cover
⑩
Power Driver
Driver Tray
s
Fig. F-2
Seal
Nut
Seal
Nut
Seal Ring
Seal Ring
Seal Clamp
O-Ring
O-Ring
Housing
Connector
AC
Cable
AC
Cable
Seal Clamp
⑨
