Pangolin Laser Systems
FB4 quick start guide
Page 4 of 10
Getting started
When using FB4 for the first time. Take the following steps:
1.
Make sure the included microSD card is properly inserted in the microSD slot
2.
Connect an ethernet cable between the network port on FB4 and your
computer
3.
Turn on the power to FB4
4.
Wait until FB4 has acquired an IP address. The yellow LED should blink once a
second. (See the section “Status LEDs” for more information)
5.
Start Pangolin Laser Show Designer Quickshow or Beyond on your computer
6.
The PC should now connect to FB4
