Panduit TDP42H, Operator'S Manual

Page: 54 / 84

PANDUIT TDP4*H GMTDPH-MAN
Page 3-28
Section 3: Configuration
2. Press the LINE key. The printer is now waiting for the data to
be sent.
3. Transmit the download data command stream to the printer.
4. After the data has been received, the printer will beep and print
a status label. If it does not beep and print a status label, the
printer did not accept the data.
5. If the printer did not beep and print a status label, turn the
printer off and check your data stream for errors and start the
download process over.
6. If the custom codes are correct, press the FEED key to accept
them and terminate the download process. If they are incorrect,
turn the printer off without pressing the ENTER key and begin
the process again.
HEX DUMP MODE
In addition to the Test Print Labels, the printer can print the contents of the receive buffer in a hexadecimal
format to allow the data stream to be examined for errors and troubleshooting.
USER DOWNLOAD
WAITING
Displays the firmware during the initialization.
The Hex Dump Mode is entered by placing DSW2-4 in the on
position and powering the printer on.
1. The printer is now ready to receive data.
2. Send the data stream to the printer.
3. The received data will be printed in a hexadecimal format4. To
return the printer to normal operation, place DSW2-4 in the off
position and power the printer off and then back on.
V 05.00.03.00
INITIALIZING
ONLINE
QTY:000000