For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 1 of 2
INSTALLATION INSTRUCTIONS
© Panduit Corp. 2011
CM545
Retro-Fit Kit for P
AN
Z
ONE
Wireless Enclosure
Part Number(s): PZWRKA
Retro-Fit Kit Components:
Door
Mounting Bracket
Figure 1
Figure 2.1
Figure 2.2
This Retro-Fit Kit is designed specifically for use with the PZWIFIED Wireless Enclosure.
Door Replacement
Door to be
removed
Figure 2.3
Grounding Wire
Hinge Pins-Remove using
hammer and small gauge
steel pin
(4) #8-32 Hex Nuts
(4) #8-32 X 1/4”
Screws
(2) Hinge Pins
Step 1:
Disconnect grounding wire from door to be removed. See Figure 1.
Step 2:
Remove lock from door by removing nut on inside door face. See Figure
1.
Step 3:
Remove hinge pins from door to be removed using a hammer and a small
gauge steel pin. See Figure 1.
Step 4:
Remove old door. See Figure 1.
Step 5:
Align hinges of new door to enclosure. See Figure 2.1.
Step 6:
Add hinge pins to assembly using a hammer and a small gauge steel pin.
See Figure 2.2.
Step 7:
Reconnect grounding wire. See Figure 2.3.
Step 8:
Reinstall lock onto door.
Be sure to maintain the same lock orientation
as when it was removed in Step 2
. See Figure 2.3.
Grounding Wire
Remove lock
from old door
Door Hinges
New Door
Hinge Pins-Install using
hammer and small gauge
steel pin
Lock
Complete In-Ceiling Enclosure
Assembly with Retro-fit Parts
and Wireless Access Point
