INSTRUCTIONS CM385E
For Technical Support: www.panduit.com/resources/install_maintain.asp
Page 6 of 12
Bottom Duct
[2] #10-32 Hex Nuts
(use 3/8” socket wrench)
[2] #12-24 Serrated
Hex Head Screws
REAR OF CABINET
Rear Mounting
Bracket
Attach flap seal to bottom duct as shown below. Mount bottom duct to equipment rails using (4) #12-24 serrated hex head screws as shown.
Attach rear mounting bracket to bottom duct using (2) #10-32 hex nuts with integrated lockwashers
(there are (2) pre-installed press studs on
the rear of the bottom duct)
. Adjust rear mounting bracket so that it rests against bottom of 7018 switch. Secure the bracket to rear equipment
rails using (2) #12-24 serrated hex head screws as shown.
Attach flap seal to intake duct seal bracket as shown. Mount intake duct seal bracket with flap seal to upper universal ducting bracket with
(2) #10-32 hex nuts with integrated lock washers. Positioning of intake duct seal bracket is adjustable to allow for tight seal of intake duct to
7018 switch.
Secure intake duct transition bracket to bottom duct and intake duct with (4) #10-32 hex nuts with integrated lockwashers as shown below.
Intake Duct and Bottom Duct Installation
FRONT OF CABINET
#12-24 Serrated
Hex Head Screws
(use 5/16” socket wrench)
(use 5/16” socket wrench)
Intake Duct
Flap Seal
Flap Seal
Intake Duct
Seal Bracket
Intake Duct
Transition Bracket
[4] #10-32 Hex Nuts
(use 3/8” socket wrench)
[2] #10-32 Hex Nuts
(use 3/8” socket wrench)
