Installation Guide
AT-VSP-800-BL and AT-VSP-800-WH
4
Installation and Set Up
NOTE:
Installation of the Velocity Touch Panel can only be done after the AT-VGW-
HW-3/10/20 has been set up. View the AT-VGW-HW-3/10/20 Installation Guide and
Velocity Manual for instructions.
1
Connect the Ethernet cable into the back of the unit.
a
If the Ethernet cable is connected to a non PoE switch, use a PoE injector using 802.3at
(purchased separately).
2
Secure the unit in either the wall or optional stand, as explained in the mounting instructions.
EU back box:
NOTE:
For horizontal installation, turn
the unit and mounting plate on its side.
The same back box can be used.
3. The Velocity logo will display during the booting process and will go directly into setup.
Press
CONTINUE
to start the setup process.
Initial Setup
CONTINUE
You will be guided through the setup process
in the next few screens.
