AT-UHD-CAT-8
10
4.
Connect an Ethernet cable from the
LAN
port to the Local Area Network (LAN). This step will be required in order
to access the built-in web server.
5. Connect the included power supply to the
DC 48V
connector and connect the power cord to an available
electrical outlet.
6. Connect an RS-232 or IR cable from the control system to the RS-232/IR ports. Refer to
for more information.
•
MASTER RS-232/IR
Connecting to this port will provide direct control of the AT-UHD-CAT-8 using a control system. Control can
be performed using either RS-232 or electrical IR.
•
RS-232/IR 1
through
RS-232/IR 8
Each of these ports is associated to the respective
HDBaseT OUT
port. This allows RS-232 pass-through
zone control of a display (sink) device that is connected to a PoE-compatible receiver. Control can be
performed using RS-232 or electrical IR.
1.
Connect an HDMI cable from a UHD/HD source to the
HDMI IN
port.
2.
Connect an HDMI cable from the
HDMI OUT
port to a display (sink) device.
3.
Connect up to eight Ethernet cables from the
HDBaseT OUT
ports to compatible PoE-capable receivers. Refer
to the table below for information on maximum cable length and supported resolutions.
Connection Instructions
IMPORTANT:
Stranded or patch cable is not recommended due to performance issues.
Sheilded cables are strongly recommended to minimize signal noise and interference.
Installation
Cable
4K/UHD - Feet / Meters
1080p - Feet / Meters
HDMI
15
5
30
10
CAT5e/6
115
35
200
60
CAT6a/7
130
40
230
70