Panduit Atlona AT-HDVS-150-TX-HDMI, Manual, Page: 21 / 27

AT-HDVS-150-TX / AT-HDVS-150-TX-PSK 21
6. Once the proper command strings have been entered, refer to the tables below for information on setting the
Auto Display On and Auto Display Off features.
Auto Display On
Click this drop-down list to select when the display will be powered-on, based on the detection of a source.
Auto Display Off
Click this drop-down list to select when the display will be powered-off, based on the detection of a source.
Setting Description
On
Powers-on the display when a source is detected.
Off
Display is not powered-on when a signal is detected.
Setting Description
On
Power-off the display when no signal is detected for the time interval specified
in the ProjSW Mode (sec.) drop down list.
Off
Display is not powered-off when no signal is detected.
Connecting the AT-HDVS-150-RX to the Display
Once programming is completed, connect the RS-232 cable from the AT-HDVS-150-RX to the RS-232 port on the
display or projector device, as shown in the illustration below. The display / projector will now function based on
the programming which was performed in the control software. If a change to the display behavior is desired, then
disconnect the RS-232 cable from the display, reconnect the RS-232 computer to the AT-HDVS-150-RX, launch the
control software, and make the necessary changes.
HDBaseT
IN
FW
DC
48V
+
HDMI
HDMI
RS-232
HDBaseT
AT-HDVS-150-RX
AT-HDVS-150-TX
Laptop
Display
Solution Setup and Configuration Guide