Panduit ATLONA AT-HDR-CAT-4ED, Installation Manual

Page: 6 / 8

6
Installation Guide
AT-HDR-CAT-4ED
DC 48V
IR RS-232
RX TX RX TX
HDMI
IN OUT 1 2 3
HDBaseT OUT
LAN
4
IR
RX TX RX TX
RS-232
1
IR
RX TX RX TX
RS-232
2
IR
RX TX RX TX
RS-232
3
IR
RX TX RX TX
RS-232
4 AUDIO OUT
R L
AT-HDR-CAT-4ED
OUT IN
HDMI
4 3 2 1
HDBaseT LOCK INT LEARN
FW EDID POWER
The AT-HDR-CAT-4ED is shipped with DHCP enabled. Once connected to a network, the DHCP
server (if available), will automatically assign an IP address to the unit. If the AT-HDR-CAT-4ED
is unable to detect a DHCP server within 15 seconds, then the unit will use a self-assigned IP
address within the range of
169.254.xxx.xxx/16
. If this occurs, refer to the AT-HDR-CAT-4ED
User Manual for more information.
Use an IP scanner, along with the MAC address on the bottom of the unit, to identify the unit on
the network. If a static IP address is desired, the unit can be switched to static IP mode.
IP Configuration
Switching the IP mode using the Front Panel
1. Make sure the AT-HDR-CAT-4ED is powered.
2. Connect an Ethernet cable between the LAN port of the AT-HDR-CAT-4ED and the Local
Area Network (LAN).
3. Press and hold the POWER button for approximately 15 seconds. Release the POWER
button once all the front-panel LED indicators begin to flash. The number of flashes will
indicate the currently selected IP mode. Refer to the table, below.
POWER button flashes Description
Two Static IP mode IP address:
192.168.1.254
Netmask:
255.255.0.0
Gateway: 192.168.1.1
Four DHCP mode
LOCK LED indicator
POWER button
Switching the IP mode can also be performed using commands or the built-in web server.
Refer the AT-HDR-CAT-4ED User Manual for more information.