4
Installation Guide
AT-AVA-EX70C-KIT
Two captive screw connectors for IR have been included. A 4-pin connector for the transmitter
and a 3-pin connector for the receiver.
IR IN
is connected by a power, ground, and signal
wire. Use a 12V IR receiver with it
(
e.g.
AT-IR-CS-RX
purchasable through atlona.com)
.
IR IN
is connected by a ground and signal wire. Use
with 3rd party control systems. For easy termination,
Atlona recommends using the 2 meter IR cable AT-LC-
CS-IR-2M
(purchasable through atlona.com)
.
IR OUT
is connected by a ground and signal wire.
Use the included IR emitter with this port.
IR OUT
is connected by a ground and signal wire.
Use the included IR emitter with this port.
IR
IR IN
IR OUT
GND
S
S
P
IR IN
IR OUT
GND
S
S
1. Connect a source to the
HDMI IN
port on the transmitter.
2. Connect a display to the
HDMI OUT
port on the receiver.
3. Connect an HDBaseT cable, from the
HDBaseT OUT
port on the transmitter, to the
HDBaseT IN
port on the receiver.
4.
*Optional*
Connect a 3rd party controller to the transmitter using either the 3-pin RS-232
or the 2-pin IR IN ports.
5.
*Optional*
Connect an IR receiver to the IR IN port of the receiver.
6.
*Optional*
Connect an IR emitter to the IR OUT port of the transmitter or receiver.
7. Connect the included 48V power supply into the transmitter.
8. Connect power supply to an AC outlet.
Installation
