Panduit Atlona AT-AVA-EX70C-KIT Installation Manual Download Page 1

1

Installation Guide

AT-AVA-EX70C-KIT

4K/UHD HDMI Extender Kit with Control and Remote Power

AT-AVA-EX70C-KIT

The Atlona AT-AVA-EX70C-KIT is an Avance™ Series HDBaseT transmitter and receiver set 

that supports control pass-through and remote power capability. The kit transmits 4K/UHD 

60Hz 4:2:0 video up to 130 feet (40 meters) or 1080P 60Hz video up to 230 feet (70 meters). In 

addition to video with embedded multi-channel audio, RS-232 and IR control signals, and remote 

power from the transmitter to the receiver are supported on the single CAT6A/7 cable. Integrated 

HDBaseT link status testing allows quick verification of cable, termination, and link quality. HDMI 

clock stretching and EDID filtering are included to ensure the integrity of video transmission as 

well as compatibility with the widest array of sources and display devices. Compact enclosures 

and included brackets allow the transmitter and receiver endpoints to be surface mounted 

in furniture or behind a display. The AT-AVA-EX70C-KIT delivers a cost-effective solution for 

extension of video, audio, control, and receiver power at resolutions up to 4K/UHD.

IMPORTANT

: Visit 

https://atlona.com/product/AT-AVA-EX70C-KIT

 for the latest firmware 

updates and Installation Guide.

1 x AT-AVA-EX70C-TX

1 x AT-AVA-EX70C-RX

1 x 2-pin captive screw connector

2 x 3-pin captive screw connector

1 x 4-pin captive screw connector

1 x 5-pin captive screw connector

1 x IR emitter

4 x Mounting brackets

8 x Mounting screws

1 x 48V DC power supply

1 x IEC cable

1 x Installation Guide

Package Contents

Summary of Contents for Atlona AT-AVA-EX70C-KIT









Reviews: