22
PA N D O R A S M A R T M O T O V 2
Wiring description
Connector Х1 (micro-USB)
This connector is used to configure and update the system via a USB cable connected to a computer
with Pandora Alarm Studio.
Connector Х2 (Main connector)
The main connector has multi-function inputs (INP) and outputs (CH) with the factory-preset logic.
The logic of the channels can be changed in the Inputs/Outputs and Time Channels settings. It is also
possible to re-program type of an input (INP) from normally open (NO) to normally closed (NC) in the
input settings.
• Wire №1 | Red | POWER (+12V)
— System power supply. It should be connected to reliable
conductor with constant voltage of 12V
• Wire №2 | Black | GROUND (-)
— Ground. It should be connected to a vehicle grounding spot (-).
This wire should be connected FIRST during installation.
• Wire №3 | White | t
0
sensor
— Connect a temperature sensor to this wire. Factory logic is “Engine
temperature”. Connect this wire to the red wire of the sensor. The black wire of the sensor is connected
to a vehicle grounding spot.
• Wire №4 | White-Red | LED/VALET
— Connect this wire to the red wire of the LED/VALET button.
• Wire №5 | Yellow | (+) | INP1
— Factory default logic is “Ignition”. Connect this wire to the ignition
switch or to the appropriate wire where 12V voltage appears when ignition is switched on and does not
disappear until the moment ignition is disabled.
!
c
onnecTion
of
This
wire
is
mandaTory
.
• Wire №6 | Green | 200mA (-) | INP2/CH4
— Factory default logic is “NC Blocking”. The channel
is used to control a blocking relay with normally closed logic. The channel is enabled (blocking is
activated) when the ignition is switched on in the armed mode or there is no radio tag in the coverage
zone when ignition is switched on (in the Immobilizer mode).
• Wire №7 | Gray | 200mA (-) | CH1/INP4
— Factory default logic is “Clutch”. Input for arming/
disarming when an authorization device is in the zone (1.2.4 setting “Arming/Disarming by a clutch
handle). Connect this wire to a wire that becomes grounded when the clutch handle is pressed.
• Wire №8 | Orange | 6A (+) | CH7
— Factory default logic is “Turn indicators”. Connect this wire to
(+) control wire of the left or right turn indicators.
• Wire №9 | Orange | 6A (+) | CH6
— Factory default logic is “Turn indicators”. Connect this wire to
(+) control wire of the left or right turn indicators.
Summary of Contents for SMART MOTO V2
Page 45: ...45 USER MANUAL...
Page 46: ...46 PANDORA SMART MOTO V2...
