17
16
U S E R MA N UA L
PA N D O R A E L I T E V2
AN EXAMPLE OF USING THE FUNCTION
• Turn on the ignition to disable engine blocking or enable service mode, turning on the ignition is not
required if you want to disarm the system or control time channels.
• Enter the “Immobilizer PIN-code”. Press a programmed button/lever/pedal the number of times
equals to the first digit. Pauses between presses should not exceed 1 second. More than 1 second
pause will be interpreted as the start of the next digit input. The immobilizer code can consist max
of 4 digits from 1 to 9.
• The system will confirm the correct input by a sound signal of the beeper and a programmed
• function will be performed.
!
t
hIs
mode
Is
dIsAbled
by
defAult
. t
hIs
mode
cAN
be
set
oNly
by
A
pRofessIoNAl
specIAlIst
.
Checking the number of paired devices
The number of paired radio tags/mobile device can be checked by the number of flashes of the
LED indicator. The number of tags/mobile device can be checked when switching on the ignition (the
system must be disarmed). The number of green flashes will indicate the number of paired radio tags, a
following red flash will indicate a paired mobile device.
You can also check the number of paired radio tags/mobile device by taking off and putting back on
battery terminal. The system will emit short sound signals from a siren
:
• First series of the siren signals
– indicates the number of paired radio tags;
• The second long signal
after a pause of 2 seconds indicates a paired mobile devices.
REMOTE CONTROL D-043
A two-way remote control is a mean of control over the system.
For easily distinguishable notifications the remote uses 16 ringtones. Each ringtone matches a
particular event. Remote has flashing LED indicators for additional information.
The remote is fully operational when shipped. To switch on the remote, press and hold the
button for 3 seconds. The “REMOTE ON” ringtone will play. Pressing and holding this button again for 3
seconds will cause the remote to switch off.
!
A
ll
coNtRol
commANds
ARe
tRANsmItted
vIA
RAdIo
chANNel
,
foR
mAxImum
effectIveNess
ANd
RANGe
It
Is
RecommeNded
Not
to
shIeld
AeRIAl
AReA
(
see
pIctuRe
)
WIth
fINGeRs
WheN
usING
A
Remote
coNtRol
.
!
A
Remote
coNtRol
Is
A
uNIfIed
coNtRol
devIce
. I
ts
fuNctIoNs
depeNd
oN
secuRIty
system
model
.
868MHz
Antenna
SEND/ALARM
Indicator
OLED-
DISPLAY
micro-USB
ARM
DISARM
Unlock trunk
Beeper
