Pando PLT-7460, Installation And User Manual

Page: 16 / 60

Water Softener
The water softener must be set manually, using the water hardness dial.
The water softener is designed to remove minerals and salts from the water, which
would have a detrimental or adverse effect on the operation of the appliance.
The more minerals there are, the harder your water is.
The softener should be adjusted according to the hardness of the water in your area.
Your local Water Authority can advise you on the hardness of the water in your area.
Adjusting salt consumption
The dishwasher is designed to allow for adjustment in the amount of salt consumed
based on the hardness of the water used. This is intended to optimise and customise
the level of salt consumption.
Please follow the steps below for adjustment in salt consumption.
1. the door, on the appliance;
2.
3. Press the to select the proper set according to your local
environment, the will change in the following sequence:
H1->H2->H3->H4->H5->H6;
4. Press the Power button to end the .
Open
‘ ’
‘>’ button
switch
Within 60 seconds after the appliance was switched on, press the Program button “
>
”
for more than 5 seconds, then press
+
to enter the water softener setting mode.
again
setting
setting mode
0 - 5
6 - 11
12 - 17
18 - 22
23 - 34
35 - 55
German
dH
German
dH
0 - 9
10 - 20
21 - 30
31 - 40
41 - 60
61 - 98
0 - 6
7 - 14
15 - 21
22 - 28
29 - 42
43 - 69
0 - 0.94
1.0 - 2.0
2.1 - 3.0
3.1 - 4.0
4.1 - 6.0
6.1 - 9.8
French
fH
French
fH
Mmol/l Mmol/l
British
Clarke
British
Clarke
WATER HARDNESS
Salt consumption
(gram/cycle)
H1
H2
H3
H4
H5
H6
0
9
12
20
30
60
No regeneration
Water softner
level
Regeneration occurs
every X program
sequence 1)
10
5
3
2
1
dH=1.25 Clarke=1.78 fH=0.178mmol/l
° ° °
1
The setting: H3 factory
Every cycle with a regeneration operation consumes additional 2.0 litres of water,
the energy consumption increases by 0.02 kWh and the program extents by 4
minutes. 1)
16