PANCONTROL PAN 600AD+, Manual

Page: 36 / 194

EN 12
Auto power off
If no further measurements are carried out, the device switches off
automatically after 10 minutes.
DC current- / AC Current measurement
(Note Fig. 1)
All current measurements are carried out only through the pliers.
Always measure current on one conductor only.
Covering more than one conductor results in measuring differential current
(like identifying leakage current). To avoid measuring errors related to other
hot conductors, please observe maximum phase-to-phase clearance.
1.
Switch on the device with the rotary switch.
2. Press the lever to open the induction jaw.
3. Place the wire in the center of the pliers opening as far as possible and
close the measuring pliers again.
4. Once the reading stabilizes, read the value. If the polarity is twisted a
"Minus sign" is displayed.
When measuring alternating voltage/alternating current, the frequency is
displayed in the secondary display.
DC Voltage measurement
(Note Fig. 2)
1. Switch on the device with the rotary switch.
2. Attach the pin-plug of the black test lead to the COM-jack and the
pin-plug of the red test lead to the VΩ-jack.
3. Touch the measuring points with the probe tips.
4. If the input signal is >=0.5 V, the voltage is displayed. (V) An input signal of
<0.5 V indicates the resistance. (Ω)
5. Once the reading stabilizes, read the value. If the polarity is twisted a
"Minus sign" is displayed.