P
a
n
chromatic
Eumig P26
User Manual
6
www.Panchromatic.co.uk
Lead the film over the small guide roller and down below the top
sprocket
1
(
Fig.A
), then pass it between the two guide plates, when a
gentle upward tension will engage the film with the sprocket teeth.
Open the film gate by turning the lever
5
(
Fig.A
) under the lens
mounting the lens having been somewhat screwed out, if necessary,
and insert the film sideways into the gate, then close the gate. The film
is then passed around the bottom sprocket
11
(
Fig.A
). under the second
small guide roller on to the emply film spool. A loop must be left
between the top sprocket and the gate, while another loop is left before
passing the film around the bottom sprocket.
PROJECTION.
Having arranged the projector at on appropriate distance from the
screen, switch on by the lever
17
(
Fig.A
) and focus by turning the lens
mount. Adjust the speed by lever
21
(
Fig.A
) until all flicker is removed.
If parts of two pictures are to be seen on the screen, framing is effected
by turning the lever
13
(
Fig.A
), Stills, by turning the knob
25
(
Fig.A
),
may be shown for a longer or shorter space of time, according to the
kind of film used, an adequate cooling of the film being effected by a
newly designed, highly efficient fan. Moreover, a heat absorbing filter is
provided for the projection of still pictures.
REWINDING.
First place the lever
25
(
Fig.A
) Into the "still" position. Disconnect belt of
upper spool arm and place an the inner groove of the double pulley
12
(
Fig.B
). Remove the belt from the lower spool arm. The projector is
switched for forward motion by lever
19
, (
fig.A
). Lead the film directly
from the lower to the upper, empty reel. Switch on with switch
15
(
Fig.
A
) and regulate speed of rewind by means of lever
21
(
Fig.A
).
MAINTENANCE.
The projector and especially the parts being in contact with the film,
must be kept scrupulously clean. To facilitate cleaning the entire gate
mechanism may be withdrawn by opening lever
5
(
Fig.A
), but before
doing so, care must be taken to turn the main driving wheel
8
(
Fig.B
)
until the dot marked on the same Is on the top. In this position the
