Installation and Configuration
3
Step 1. Unplug the power cord from the power module which is going to be
replaced and removed, and shut off the power.
Step 2. Make sure that the power status LED of the power module and the
POWER1 LED, the POWER2 LED or both LEDs of the Ethernet switch itself
are turned off.
Step 3. Push the power module's release lever (black) in to the left side, and
release the retainer.
Step 4. Hold the power module’s handle (black), and slowly pull out the power
module while supporting it.
16
Removing the power module
Step 1. Remove the blank panel on the power module slot. Carefully store the
removed blank panel.
Step 2. Insert the power module into the power module slot until a “clunk” is
heard.
Step 3. Attach the power cord on to the power module.
Step 4. Make sure that the power status LED of the power module and the
POWER1 LED, the POWER2 LED or both LEDs of the Ethernet switch itself
are turned off.
Mounting the power module
After removing the power module, then mount the power module.
Replacing the power module
Power module slot
Power module 1
Power status LED
Handle (black)
Release
Release lever (black)
Blank panel
