15
ENGLISH
J
K
L M
N O
J
Extension receiver connector [RCVR IN]
Connect the receiver (EXT OUT) and the extension receiver (RCVR IN) with a LAN
cable (page 17).
K
Channel output connectors [CH OUT -10 dBV 600 Ω 1/2/3/4]
Individually outputs the audio from each channel.
L
External input connector [AUDIO IN -10 dBV 600 Ω]
Takes external audio input to be mixed and sent to the mix output connector.
M
Mix output connector [MIX OUT -10 dBV 600 Ω]
Outputs audio obtained by mixing the audio from each channel with the audio input from
the [AUDIO IN] connector.
N
SIGNAL GND connector [SIGNAL GND]
Gathers the SIGNAL GND from external devices to eliminate electrical potential
difference.
O
Power cord
Connect the power cord to an AC 120 V 60 Hz power source.
Rear
Installation
■
Installation precautions
Warning
Always ask a retailer to perform these operations.
Before installation, set the power switch on the devices
you want to connect to OFF.
Carefully read the “Precautions” section and follow all of
its instructions. Also refer to the manual of the devices
you are connecting.
If this product is used in a residential environment, it
may cause wireless interference.
When installing this product, follow all official ordinances on electrical equipment
technical standards.
This product is intended for indoor use only
It cannot be used outdoors.
Avoid exposing the product to direct sunlight for extended periods of time, and do not
install it near air conditioners or heaters. Failing to do so may lead to damage to the
shape and color of the product, and may cause it to malfunction. Also avoid exposure to
water droplets and bubbles.
Turn the product OFF to install it
Remove the power cord from the power socket before performing these operations. Also
turn OFF all mixers, amplifiers, and other devices connected to the extension receiver.
Failing to do so will result in a loud noise coming out of the speakers and possibly
damaging the system.
Installation place
This product produces a large amount of heat.
When installing product near a wall or ceiling, make sure it has at least 10 cm (3-15/16
inches) of clearance on all sides (see figure below).
At least
10 cm
(3-15/16 inches)
At least 10 cm
(3-15/16 inches)
At least
10 cm
(3-15/16 inches)
Wall
Front
side
Place the product on a flat surface. Do not place it upright with the rear surface facing
downward.
PUQX1022YAV6_WX-SE200P_OI_en-fr.indb 15
2022/03/23 10:21:38
