16
Installations/connections
Installation
Before starting installation/connection, make sure that the power plug is not connected to an outlet.
Read the "Precautions for installation" section before starting installation/connection.(
☞
page 13)
Step 1
Remove the screw (M3 x 6) fixing the camera and the
base unit.
• Do not lose it since it is to be used to fix the cam-
era and the base unit again.
Step 2
Detach the base unit.
• Rotate the base unit to the direction as indicated
by the arrow mark as shown in the illustration, and
detach it.
Step 3
Manufacture the camera and the decorative cover.
• It is necessary to fabricate the camera body and
the decorative cover to pull out the cables (power,
monitor out, LAN, alarm in/out, audio in/out) from
the side of the camera.
Refer to the following illustrations for how to fabri-
cate the camera body and the decorative cover.
[Fabricate the die-cast case of the camera]
* Mat a soft cloth when fabricating the die-cast body
of the camera body to prevent to scratch the dome
cover.
[Fabricate the decorative cover]
Fixing screw
Detach the dome
cover by pushing
upward after
loosening the
screws.
Bend and
remove it
using pliers,
etc.
Remove it using
a cutter, etc.
Rotate
15
°
Detach the base unit
after pushing it upward.
