-22-
To reset to the factory settings (CAMERA RESET)
1. Move the cursor to CAMERA RESET. PUSH SW is
highlighted.
2. While holding down
L
and
M
, hold down
I
for 2 seconds or more. The camera is reset to the
factory settings.
NETWORK SETUP
Set up network parameters when connecting the
10/100BASE jack with a network.
Notes:
• Access the setup menu from the PC to use the
DHCP or DNS server, because these settings are
not included in this window.
• Ask your system administrator or ISP (Internet
Service Provider) about available IP address, sub-
net mask, and gateway, prior to setup.
• The assigned address should be a global type
when connecting via the Internet. Ask your ISP
whether it is.
1. Move the cursor to NETWORK SETUP in the SETUP
menu window and press
I
. The NETWORK
SETUP menu opens.
The factory default settings are as follows.
IP ADDRESS:
192.168.0.10
NETMASK:
255.255.255.0
GATE WAY:
192.168.0.1
HTTP Port Number:
80
2. Move the cursor to the line you wish to edit, and
press
I
.
Parameters become editable.
3. Select a digit using
J
or
K
.
4. Select a number in the digit using
L
or
M
.
5. Repeat steps 2, 3 and 4 above appropriately until
all parameters are set.
6. Move the cursor to END and press
I
to close the
setup menu and store new settings, or select RET
to go back to the SETUP menu.
Note:
The port number assigned to the camera is
exclusive, and any other usage is not allowed.
** NETWORK SET UP **
IP ADDRESS
192.168. 0. 10
NETMASK
255.255.255. 0
GATEWAY
192.168. 0. 1
HTTP PORT NO. 80
RET END
