14
Installations/Connections
Before start the installation/connection, prepare the required devices and cables.
Before starting the connection, turn the power of the devices including the camera and the PC
off or disconnect the AC adapters from the outlet.
Step 1
Fix an optional camera mount base onto the
desired place and mount the camera on it.
When attaching an optional camera mount
base on the bottom of the camera, use the
removed screws to attach the camera mount
base.
Otherwise, it may cause a drop or malfunc-
tion.
<Example>
Important:
Method of installation may be different
depending on the material of the place
where the camera is to be installed.
Step 2
Connect the monaural mini plug (ø3.5 mm) to
the monitor out connector (for adjustment) on
the rear of the camera. (Only when adjusting
the angular field of view)
Important:
The monitor out connector is provided
only for checking the adjustment the
angular field of view on the video monitor
when installing the camera or when serv-
icing.
It is not provided for recording/monitor-
ing use.
Step 3
Connect the power cable.
• When using AC 24 V/DC 12 V power
supply
• When using PoE (Power over Ethernet:
IEEE802.3af compliant)
Connect a LAN cable (category 5 or bet-
ter) between a PoE device (such as a
PoE hub) and the network connector of
the camera.
Fixing screw
Tripod mount base
INITIAL SET
GND
POWER
10BASE-T/
100BASE-TX
SD
CARD
MONITOR OUT
EXT I/O
1 2 3 4
LINK
ACT
AC 24V IN : 1L – 2N
DC 12V IN :
!
–
@
Connect to the video
monitor, etc.
+
–
DC12 V
AC24 V
GND wire
GND
POWER
SD
CARD
EXT I/O
1 2 3 4
AC 2 4 V I N : 1 L – 2 N
D C 1 2 V I N :
!
–
@
