15
Precautions for installation
In order to prevent injury, the product
must be securely mounted to a ceiling or
floor according to Installation Guide.
Always connect to the main power outlet
with protective grounding.
About grounding
• Please make sure that the grounding is
installed securely and correctly before
usage. Please check the ground resistance
value (100 Ω or less) when using an outlet
with a ground terminal.
• Always perform ground connection before
connecting the power plug to the main
power. In addition, always unplug the
power plug from the main power before
ground disconnection.
When installing this product in coastal
areas
• The camera has heavy salt damage resis
-
tance treatment applied, but this does not
ensure complete resistance against corro-
sion. Please pay attention to the installa-
tion location such as in places where sea-
water does not splash directly.
• Especially when installing this product in
coastal areas and area that are sprayed
with snow-melting agent that are not
exposed to rainwater, periodically clean by
rinsing to remove adhered salt.
• Periodically inspect the camera when
installing it in coastal areas or areas that
are sprayed with snow-melting agent.
(Replace parts as necessary.)
• Prepare the foundation of the installation
site, installation support, and any other
installation setting with heavy salt damage
resistance treatment.
Installation area for this product
Select an appropriate place for the installation
area (such as a strong ceiling or floor) in your
particular environment.
• Make sure that the installation area is
strong enough to hold this product, such
as a concrete ceiling or floor.
• Install the camera in the foundation area of
the architecture or where sufficient strength
is assured.
• Do not mount the product on a plaster
board or a wooden section because they
are too weak. If the product is unavoidably
mounted on such a section, the section
shall be sufficiently reinforced.
How to install the camera
This product is for hanging and stationary use
only. If used on walls or in tilted position, this
product may fail to operate properly or its lifes-
pan may be shortened.
Do not expose the camera to the high-
intensity light source like sunlight.
Due to the incidence angle of the high-intensity
light source like sunlight or a lighting lamp, a
picture that does not exist (reflected light) may
enter the camera and create a phenomenon
called ghosting in the screen. This phenome-
non noticeably appears with LED lighting in
particular.
Do not place this product in the following
places:
• Locations where a chemical agent is used
such as a swimming pool
• Locations subject to moisture or oil smoke
such as a kitchen
• Locations that have a specific environment
that is subject to an inflammable atmo-
sphere or solvents
Panasonic assumes no responsibility for injuries or property damage resulting from
failures arising out of improper installation or operation inconsistent with this
documentation.
For information about the installation tasks, refer to the provided Installation Guide.
