There are 2 pieces of protective packaging used inside the front
cover of the camera that are used to protect the camera during
shipping.
Before turning the power on for the camera, make sure to
remove all of the protective packaging from inside the front
cover.
After removing the protective packaging, reattach the front cover
with the protection cover fixed to it to the camera, and then install
the camera.
＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿
Note:
● If the power for the camera is turned on with the "lens spacer" (see in the diagram above) inserted, the zoom
lens position may move out of alignment causing the camera to go out of focus.
In this case, remove the "lens spacer" and then restart the camera.
* There are 2 ways to restart the camera as follows.
①
Disconnect and then reconnect the power for the camera.
② Restart the camera from the setting screen.
(Refer to the Operating Instructions on the provided CD-ROM for further information.)
＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿＿
Remove the protective packaging from inside the front cover (before turning on the power)
