15
Parts and functions
WV SFN130
-
About the initial set button
Follow the steps below to initialize the network camera.
A
Turn off the power of the camera.(Disconnect the Ethernet cable from the camera.)
B
Turn on the power of the camera while holding down the INITIAL SET button, and then keep
holding down the button for 10-15 seconds. In about 2 minutes later, the camera will start up
and the settings including the network settings will be initialized.
IMPORTANT:
• When the camera is initialized, the settings including the network settings will be initialized.
Note that the CRT key (SSL encryption key) used for the HTTPS protocol will not be initial-
ized.
• Before initializing the settings, it is recommended to write down the settings in advance.
• Do not turn off the power of the camera during the process of initialization. Otherwise, it may
fail to initialize and may cause malfunction.
Enclosure
Dome cover
SD memory
card slot
Network connector RJ45
Built-in
microphone
Lens
INITIAL SET button
LINK indicator
ACT indicator
SD CARD indicator
Lens body
