16
A
RJ45 Network cable
Connect an Ethernet cable (category 5e or better, straight) to the network connector.
IMPORTANT:
Use all 4 pairs (8 pins) of the Ethernet cable.
The maximum cable length is 100 m {328 feet}.
Make sure that the PoE device in use is compliant with IEEE802.3af standard.
When connecting both the 12 V DC power supply and the PoE device for power supply, 12 V
DC will be used for power supply.
When the Ethernet cable is disconnected once, reconnect the cable after around 2 seconds.
When the cable is quickly reconnected, the power may not be supplied from the PoE device.
■
Cables
B
Power supply terminal (12 V DC) / 2P power cable (accessory)
Connect the output cable of the DC power supply to the 2P power cable (accessory).
Caution:
A READILY ACCESSIBLE DISCONNECT DEVICE SHALL BE INCORPORATED TO THE
EQUIPMENT POWERED BY 12 V DC POWER SUPPLY.
ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY (UL 1310/CSA 223) or LIMITED
POWER SOURCE (IEC/EN/UL/CSA 60950-1).
A
RJ45 Network cable
B
Power supply
terminal (12 V DC)
C
Audio input cable (white)
D
Audio output cable (black)
E
4P alarm cable
(accessory)
B
2P power
cable
(accessory)
E
Alarm I/O cable
Ethernet
cable (category 5e
or better, straight)
12 V DC (red)
GND (black)
F
MONITOR OUT terminal
(factory shipment: NTSC monitor)
