Decoration cover (1)
Decoration cover (2)
5
Remove the Decoration Cover in order (1)
then (2).
The Decoration Cover can be removed by
pressing on the points (1) at one place, and
(2) at 4 places.
6
Fix the Camera Mounting Base (provided with
the camera) to the bracket with the four M4-
L8 Screws (provided).
Recommended tightening torque: 1.56 N
·
m
{1.16 lbf
·
ft}
Note:
Be sure to fix the Camera Mounting Base in
the up direction as shown.
Clamp
7
Run the cable around the outside and secure
it with the clamp.
Secure the cable with the clamp so it goes
along the inside of the top case so it does not
get in the way when attaching the case and
installing the camera.
8
Attach the top case to the wall and run the
cables.
Attach it with four screws. Screws are not
provided. Align it with the position the camera
will be installed.
Decoration cover (2)
9
Place the removed Decoration Cover(2) back
on the bracket and camera.
Note:
Push the Decoration Cover up till it fits
over the bracket with a click.
Ring of the Fall
Prevention Wire
10
Suspend the Fall Prevention Wire from the
Camera Mounting Base.
Notes:
• Make sure that the wire matches the Fall
Prevention Wire Fixing Angle.
• The bracket is not shown in the illustration.
15
°
Camera
Mounting
Base
Camera
Rotate
Press up
11
Attach the camera to the Camera Mounting
Base, turn the camera clockwise, and tight-
en the Mounting Screw (M3, provided).
Recommended tightening torque: 0.68 N
·
m
{0.51 lbf
·
ft}
Notes:
• Tigthen the Camera Fixing Screw with a
screwdriver.
• In attaching the camera to the Camera
Mounting Base, loosen the Camera Fixing
Screw (M3), then tighten it back with a screw-
driver while keeping it pushed up.
• The bracket is not shown in the illustration.
Decoration cover (1)
12
Place the removed Decoration Cover (1)
back on the bracket and camera.
Note:
Push the Decoration Cover up till it fits over
the bracket with a click.
Ambient Operating Temperature:
10˚C - +50˚C {14˚F – 122˚F}
Dimensions:
165 (W) x 140 (H)
×
217.5 (D) mm
{6-1/2” (W) x 5-33/64” (H)
×
8-37/64” (D)}
Weight:
650
g
{1.43 lbs}
Weight and dimensions indicated are approximate.
Specifications are subject to change without notice.
SPECIFICATIONS
STANDARD ACCESSORIES
Screw (M4-L8) ..................................................... 4 pcs.
Screw
(M4-L4) ..................................................... 4 pcs. (spare)
Template ................................................................. 1pc.
Protection Cover ..................................................... 1pc.
