Two spacer nuts are needed to use the exist-
ing anchor bolt instead.
5.
Attach the end of the Fall Prevention
Wire to the bracket.
5-1. Put a standard anchor nut onto
anchor bolt (2).
5-2. Remove the Fall Prevention Wire
from the Fall Prevention Angle
Clip.
5-3. Insert the anchor bolt (2) through
side “1”.
5-4. Fold (manually bend the clip) side
“2” down onto side “1” (when fold-
ed properly side “1” and side “2”
should match).
5-5. Reattach the Fall Prevention Wire
to the matched holes of side “1”
and “2” of the Fall Prevention
Angle Clip.
5-6. Put two standard anchor nuts onto
anchor bolt (2).
5-7. Tighten the three nuts to fix the Fall
Prevention Angle Clip.
6.
Connect the Fall Prevention Wire and
put the bracket into the suspended ceil-
ing through the hole.
7.
Fix the camera mount bracket to the
suspended ceiling by rotating the four
ceiling panel screws clockwise.
8.
Mount the bracket onto anchor bolt (1).
- 3 -
5-1
5-3
5-2
5-4
5-5
5-6
Side "1"
Anchor bolts
Side "2"
Existing anchor bolt
Spacer nuts
Spacer nuts
Fall Prevention Wire
Fall Prevention Angle Clip
Ceiling support
Clockwise
Anchor nut
Nuts
Ceiling panel
screws
WV-Q116E_E.qxd 05.2.2 11:05 Page 3