![background image](http://html.mh-extra.com/html/panasonic/wv-cs580-g/wv-cs580-g_installation-manual_277854018.webp)
18
5. Connect the cables.
Please refer to page 20 for the details of connections.
6. Attach the safety wire for securing the camera to the
camera mounting base.
Pull on the safety wire to make sure its ring is securely
connected to the camera mounting base hook.
If the dust protect sheet that comes with the camera
is affixed to the camera mounting base, remove it
before performing the above step.
Safety
wire ring
Note:
• The safety wire is designed to allow the camera
to hang from it. Do not apply force greater than
the weight of the camera to the wire.
7. Install the camera onto the camera mounting base.
Aligning with the camera mounting base, press
down on the camera as far as it will go and rotate in
the direction indicated by the arrow.
Camera
Camera
Mounting
Base
Rotate
15
°
Note:
• To prevent damage, please do not rotate while
holding the dome cover.
8. Use the fixing screw you removed in step 1 to
secure the camera to the camera mounting base.
Important:
• Recommended tightening torque: 0.68 N
.
m.
9. Check the installation.
• Is the camera is level and installed securely?
• Is the camera free of looseness?
• Does the fixed part of the camera remain in place
when you try to rotate it?
10.Separate the two parts of the decorative cover
(comes with camera).
Press upwards on the decorative cover at the points
marked
(indicated by the arrows, in the
illustration below) to unhook the two parts from each
other.
* When removing the decorative cover, the direction
to press (
) is shown on the side of the decorative
cover.
Unhook
Back
Fix securely
Press
Fix securely
Press
Caution:
• Pressing up on the wrong side of the decorative
cover can damage it.
11.Put the two pieces of the decorative cover on the
left and right side of the camera, and hook them
together.
Align the hooks and press the piece indicated by the
arrow in the illustration below into the other piece.
Back
Align
hook
12.Slide the decorative cover up to the ceiling.
• In the case of a top cable exit configuration, slide
the decorative cover straight up and press it firmly
against the ceiling.
• In the case of a side cable exit configuration, align
the cut-out in the decorative cover with the cables
as you slide it up, and press it firmly against the
ceiling.
Top Cable Exit
Configuration
Side Cable Exit
Configuration
Align with cut-out
Caution:
• Please securely fix the 4 hooks inside the
decorative cover onto the camera.