Panasonic WORKIO UB-2315C, Operating Instructions Manual, Page: 46 / 48

46
Electronic Board Operations Check
After assembling the unit, perform the procedures presented in the following table to make sure it functions properly.
Step
Points to Check
Condition Solutions
1
Turn the power switch on. Time set-up message is displayed
after initial message is displayed. (Normal operation)
(If not) Check the power cord. (See
step 8 on page 45.)
2
Set the time.
(Refer to “Setting the current
time” on page 20.) The time can be set. (Normal operation)
The time cannot be set. Contact the store or dealer from
which the unit was purchased.
3
Connect a USB flash memory
device or SD memory card.
(Refer to “Scanning” on page
14.) The USB flash memory device or
SD memory card installed is
recognized and is shown on the
display. (Normal operation)
(If not) Contact the store or dealer from
which the unit was purchased.
4
Use the accessory marker to
draw a large across
the entire scannable area of
the whiteboard surface.
•
For information on the
scannable area, refer to
“Whiteboard” on page 10.
Press the Start/Stop key.
The scanner moves smoothly and
the scanned image appears on the
display. (Normal operation)
The scanner does not move
smoothly. Check the connector.
(See step 7 on page 45.)
A strange noise is made. Check the scanner attachment.
(See step 7 on page 45.)
The scanned image is not
displayed. Contact the store or dealer from
which the unit was purchased.
The entire scannable area is not
scanned.
5
Zoom in on several areas of the
scanned image.
(See page 15 or 16.) The image on the display matches
the image on the whiteboard. (Normal operation)
A black or white horizontal line
appears on the scanned image, or
the image scanned is dark or
blank. Check the white balance area,
scanner lens and strong lighting.
(Refer to “Troubleshooting” on
page 32.)
6
Rotate the whiteboard.
(Refer to “Rotating the
Whiteboard” on page 18.) The whiteboard can be rotated
normally. (Normal operation)
The whiteboard cannot be rotated. Check the whiteboard
attachment.
(See step 6 on page 44.)
7
Turn off the power switch, then
turn back on after 3 minutes. The standby message is displayed
after the initial message is
displayed. (Normal operation)
The time is not correct. Check the battery.
(See page 31.)