-7-
■
Rack Mounting
1
Remove the four rubber feet by removing four
screws from the bottom of the unit
2
Fix the Rack Mounting Brackets (supplied ) on both
sides the unit with 4 screws (M3X10 supplied).
3
.Install the unit in the rack securing it with four
screws (not supplied).
Cautions:
• Keep the temperature in the rack below 45°C
(113°F).
• Do not block the ventilation opening or slots on the
cover to prevent the appliance from overheating.
1
+
–
SCSI ID
TERMINATION
ON
OFF
1 2 3 4
MODE
ON
Remove 4 screws
M3X10 (Supplied)
Rack Mounting Bracket (Supplied)
M5X12 (Not supplied)
Switch Settings
1
Set the MODE switch #2 on the rear of the WJ-HD500
to ON when connecting with the extension unit.
2
Set the SCSI ID for each unit by pressing the [–] and
[+] buttons on the rear of the extension unit.
0 to 5:
Are applicable to the extension unit.
Note:
SCSI ID 6 and 7 are reserved for WJ-HD500
Digital Disk Recorder.
3
Set the termination switch to ON or OFF.
ON:
Is applied to the extension unit located at the
end of the SCSI chain.
OFF:
Is used for other than the end unit.