1
Panasonic System Solutions
HD300_SATAConversionGuide_B
WJ-HD300 S-ATA conversion guide
Maintenance guide
1. Introduction
This manual describes how to convert the hard disk drive installed in the WJ-HD300 series from the P-ATA type to the S-ATA type.
Applicable models: WJ-HD309, WJ-HD316, WJ-HD309A, WJ-HD316A
2. Preparation
(1) Screwdriver
(2) S-ATA conversion kit (part number: 0E0A0027AA)
Part name
Part number
Quantity
S-ATA Board Ass’y
JH30AJKY6A
1
S-ATA cable
K1V322Y20001
1
S-ATA angle
3CA005877AAA
1
S-ATA label, small (for front, 2pcs)
3PD003840AAA
1
S-ATA label, large (for top)
3PD003841AAA
1
S-ATA leaflet
3TU001942AAA
1
(3) S-ATA HDD (250GB) x 2 (part number: HDATW250GASY)
3. Replacement Procedure
Imp++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
• Do not detach the cable connecting the unit and the front panel while the HDD status indicators are still lit or until 30 seconds have passed
since the HDD status indicators went off.
• Protect the hard disk drives from static electricity.
• Do not stack them, or keep them upright.
• Do not use an electric screwdriver to fix them. (Tightening torque: Approx. 0.49 N · m (5 kgf · cm))
• Avoid rapid changes in the temperature/humidity to prevent condensation. (Acceptable change: within 15°C/h (59 °F/h))
+++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++++
(1) Open the connectors cover on the front panel, and remove
the screw.
Then, remove the front panel by sliding it to the left.
Screw
Connectors cover
